中文：2.4寸TFT液晶屏，240*320，262K色，IPS全视角，SPI接口，COG模块，智能穿戴，智能家居面板，手持终端，便携医疗，仪器仪表，安防门禁，工控HMI，智能门锁，MP4播放器，立信智显
英文：2.4 inch TFT LCD, 240x320, 262K colors, IPS full viewing angle, SPI interface, COG FPC, smart wearable, smart home panel, handheld terminal, portable medical, instrument disy, security intercom, industrial HMI, smart lock, MP4 yer, Lesson Smart Disy
LS024I40-S-V1 2.4英寸 IPS TFT液晶屏模块 规格参数
⚙️ 基本信息
| 面板型号 | LS024I40-S-V1 |
| 屏幕尺寸 | 2.4 英寸 |
| 分辨率 | 240(RGB) × 320 |
| 显示颜色 | 262K 色 |
| 显示类型 | a-Si TFT, 透射式 (Transmissive), IPS |
| 模块类型 | COG+FPC+B/L |
| 信号接口 | 4线 SPI 串行接口 |
机械尺寸
| 模块尺寸 (H×V×D) | 42.72 × 60.26 × 2.25 mm |
| 有效区域 (AA, H×V) | 36.72 × 48.96 mm |
| 像素数 | 240(RGB) × 320 像素 |
光学特性
| 背光类型 | 白光LED (4 Chip White LED 串联) |
| 背光驱动条件 | IF=20mA, Vf=12V (TYP) |
| 典型亮度 | 规格书中未明确标注 |
| 对比度 (CR) | 规格书中未明确标注 |
电气特性
| 供电电压 (VCC) | 2.4V ~ 3.3V (典型 2.75V) |
| 接口电源 (IOVCC) | 1.65V ~ 3.3V (典型 1.8V) |
| 输入电平 (L) | VIL: ≤ 0.3*IOVCC |
| 输入电平 (H) | VIH: ≥ 0.7*IOVCC |
️ 环境与可靠性
| 工作温度 | -10°C ~ +70°C |
| 存储温度 | -20°C ~ +80°C |
| RoHS | 符合 |
适用细分应用场景（2.4英寸通用尺寸）
| ⌚ 智能穿戴 | 智能手表、运动手环、儿童手表、智能戒指 |
| 手持终端 | 对讲机、遥控器、数据采集器、智能钥匙 |
| 智能家居 | 智能温控器、智能开关面板、智能门锁显示屏、小家电显示 |
| 便携医疗 | 血糖仪、血压计、血氧仪、便携式监护仪 |
| 仪器仪表 | 万用表、示波器、实验仪器面板 |
| 安防通信 | 可视门铃、安防门禁对讲系统、楼宇对讲室内机 |
| 工控HMI | 小型PLC显示面板、工业自动化终端、嵌入式控制模块 |
| 娱乐消费 | MP3/MP4播放器、游戏机显示屏、数码相框 |
| ️ 开发评估 | 单片机开发板、树莓派扩展屏、Arduino显示模块 |
⚠️ 注意：以上参数均来源于精准匹配的官方规格书 (LS024I40-S-V1(SPEC).pdf, Revision: 1.0, 发布时间: 2026-01-23)。该型号为2.4英寸IPS全视角显示模块，采用4线SPI串行接口，240x320分辨率，可广泛应用于智能穿戴、手持终端、便携医疗、智能家居面板、仪器仪表、安防门禁及工控HMI等多种小尺寸嵌入式应用场景。该型号的规格书中未明确标注亮度、对比度等光学典型值以及驱动IC型号。背光采用4颗白光LED串联设计，驱动电流仅需20mA，典型正向电压12V。外壳设计建议：可视区域比VA单边小0.3mm以上，泡棉开窗比VA单边大0.6mm以上，TP边缘不能接触金属导体。实际使用请以样品或合同为准。该模块符合RoHS环保要求。
LS024I40-S-V1 2.4 Inch IPS TFT LCD Module Specification
⚙️ Basic Information
| Model No. | LS024I40-S-V1 |
| Screen Size | 2.4 Inch |
| Resolution | 240(RGB) × 320 |
| Disy Colors | 262K |
| Disy Mode | a-Si TFT, Transmissive, IPS |
| Module Type | COG+FPC+B/L |
| Interface | 4-Wire SPI Serial |
Mechanical Specification
| Module Size (H×V×D) | 42.72 × 60.26 × 2.25 mm |
| Active Area (AA, H×V) | 36.72 × 48.96 mm |
| Number of Dots | 240(RGB) × 320 pixels |
Optical Characteristics
| Backlight Type | 4 Chip-White LED in Series |
| Backlight Driving Condition | IF=20mA, Vf=12V (TYP) |
| Typical Luminance | Not specified in spec sheet |
| Contrast Ratio (CR) | Not specified in spec sheet |
Electrical Characteristics
| Supply Voltage (VCC) | 2.4V ~ 3.3V (Typ. 2.75V) |
| Interface Supply (IOVCC) | 1.65V ~ 3.3V (Typ. 1.8V) |
| Input Level (L) | VIL: ≤ 0.3*IOVCC |
| Input Level (H) | VIH: ≥ 0.7*IOVCC |
️ Environment & Reliability
| Operating Temperature | -10°C ~ +70°C |
| Storage Temperature | -20°C ~ +80°C |
| RoHS | Compliant |
Target Application Scenarios (2.4 Inch Size)
| ⌚ Smart Wearable | Smart Watch, Fitness Band, Kids Watch, Smart Ring |
| Handheld Terminal | Two-way Radio, Remote Control, Data Collector, Smart Key |
| Smart Home | Smart Thermostat, Smart Switch Panel, Smart Lock Disy, Home Appliance Disy |
| Portable Medical | Blood Glucose Meter, Blood Pressure Monitor, Pulse Oximeter, Portable Patient Monitor |
| Instrumentation | Multimeter, Oscilloscope, Laboratory Instrument Panel |
| Security & Communication | Video Doorbell, Security Intercom System, Building Intercom |
| Industrial HMI | Small PLC Disy Panel, Industrial Automation Terminal, Embedded Control Module |
| Consumer Electronics | MP3/MP4 yer, Game Console Disy, Digital Photo Frame |
| ️ Development & Evaluation | MCU Development Board, Raspberry Pi Expansion Screen, Arduino Disy Module |
⚠️ Note: All parameters above are based on the official Product Specification (LS024I40-S-V1(SPEC).pdf, Revision: 1.0, Released: 2026-01-23). This model is a 2.4-inch IPS full viewing angle disy module with a 4-wire SPI serial interface and 240x320 resolution. It is widely applicable for smart wearables, handheld terminals, portable medical devices, smart home panels, instrumentation, security intercoms, and industrial HMIs. Note that typical luminance and contrast ratio values are not specified in the spec sheet, and the driver IC model is not listed. The backlight uses 4 white LEDs in series with a driving current of only 20mA and a typical forward voltage of 12V. Housing design suggestion: Visual area should be 0.3mm smaller than VA on each side; foam opening should be 0.6mm larger than VA on each side; TP edge must not contact metal conductors. Actual performance may vary; please refer to samples or final contract for production. This module is RoHS compliant.
液晶屏,LCM,显示模组,液晶面板,LCD,TFT
许可项目：保税仓库经营（依法须经批准的项目，经相关部门批准后在许可有效期内方可开展经营活动，具体经营项目和许可期限以相关部门批准文件或许可证件为准）一般项目：电子元器件制造，其他电子器件制造，显示器件制造，集成电路制造，光学仪器制造，半导体分立器件制造，电子专用材料制造，电子元器件批发，电子元器件零售，光学仪器销售，半导体分立器件销售，国内贸易代理，集成电路
我司是一家专业从事触摸显示屏模组开发设计、生产及销售的的高新技术企业公司拥有较强的触摸屏及液晶显示模组设计、生产及品质控制团队；拥有国内先进生产设备，为客户提供了强大的软硬件支持。 公司专业设计生产各种标准或非标准液晶显示屏，TFT以及电容触摸屏和电阻触摸屏等产品。 我们的产品以稳定的品质广泛应用于社会各个领域：通用仪器仪表、工业控制器、通讯设备、医疗仪器、金融机具、GPS导航、POS机终端和办公自...