29寸超宽条形TFT液晶屏1920*618 LVDS接口 高亮500 高对比4000:1 数字标牌工控HMI

LS29I01-L-V1 29英寸 超宽条形 TFT液晶屏模块 规格参数

⚙️ 基本信息

面板型号LS29I01-L-V1屏幕尺寸29 英寸 (超宽条形)分辨率1920(RGB) × 618显示颜色16.7M 色 (8-bit)显示类型TFT 有源矩阵 (OpenCell)模块类型COG+FPC+B/L接口8-bit 2 Channel LVDS

机械尺寸

模块尺寸 (H×V×D)772 × 255 × 17.8 mm有效区域 (AA, H×V)698 × 225.4 mm像素数1920(RGB) × 618 像素

光学特性

典型亮度500 cd/m²对比度 (CR)Zui高 4000:1响应时间8 ~ 16 ms可视角度约 89° (广视角)LED 灯条输入电压 (VPIN)55V (Typ.), 65V (Max.)LED 灯条输入电流 (IPIN)400mA (Typ.), 480mA (Max.)LED 功耗 (PBL)22W (Typ.)LED 寿命30,000 小时

电气特性

供电电压 (VDD)12V (Typ.), 10.8V (Min. 含纹波)纹波要求应小于 VDD 的 10%

适用细分应用场景（2.9英寸超宽条形屏）

数字标牌超宽条形广告机、信息发布屏、商场导购屏、交通信息屏 智能家居智能家居中控条屏、智能面板、智能镜子显示条、智能音箱显示 车载显示车载仪表盘、车载中控条屏、车载后视镜显示、HUD抬头显示 工控HMI工业自动化条屏、PLC控制面板、设备状态显示条、生产线看板 安防监控安防监控条屏、门禁对讲条屏、视频监控显示条、楼宇对讲 仪器仪表示波器、频谱分析仪、实验仪器面板、电力监测仪表 电梯楼层电梯楼层显示条、楼宇信息引导屏、轿厢操控面板️ 开发评估嵌入式开发板、树莓派扩展屏、FPGA评估板显示、LVDS信号演示

⚠️ 注意：以上参数均来源于精准匹配的官方规格书 (LS29I01-L-V1（SPEC）.pdf, Revision: 1.0, 上传时间: 2026-04-23)。该型号为29英寸超宽条形显示模块，采用8-bit 2 Channel LVDS接口，具备1920x618超高分辨率、500 cd/m²典型亮度、Zui高4000:1超高对比度及约89°广视角，可广泛应用于数字标牌、智能家居、车载仪表、工控HMI、安防监控、仪器仪表及电梯楼层等多种超宽条形显示场景。该模块为OpenCell类型，不含LED驱动，需外部提供55V/400mA的背光驱动。供电电压VDD典型值为12V，纹波需小于10%且Zui小值不低于10.8V。实际使用请以样品或合同为准。部分光学参数为典型值，实际值可能存在±5%的偏差。该模块符合RoHS环保要求。

LS29I01-L-V1 29 Inch Ultra-Wide Bar Type TFT LCD Module Specification

⚙️ Basic Information

Model No.LS29I01-L-V1Screen Size29 Inch (Ultra-Wide Bar Type)Resolution1920(RGB) × 618Disy Colors16.7M (8-bit)Disy ModeTFT Active Matrix (OpenCell)Module TypeCOG+FPC+B/LInterface8-bit 2 Channel LVDS

Mechanical Specification

Module Size (H×V×D)772 × 255 × 17.8 mmActive Area (AA, H×V)698 × 225.4 mmNumber of Dots1920(RGB) × 618 pixels

Optical Characteristics

Typical Luminance500 cd/m²Contrast Ratio (CR)Up to 4000:1Response Time8 ~ 16 msViewing AngleApprox. 89° (Wide Viewing)LED Bar Input Voltage (VPIN)55V (Typ.), 65V (Max.)LED Bar Input Current (IPIN)400mA (Typ.), 480mA (Max.)LED Power Consumption (PBL)22W (Typ.)LED Lifetime30,000 Hours

Electrical Characteristics

Supply Voltage (VDD)12V (Typ.), 10.8V (Min. incl. ripple)Ripple Re be less than 10% of VDD

Target Application Scenarios (2.9 Inch Ultra-Wide Bar Disy)

Digital SignageUltra-wide Bar Advertising Disy, Information Kiosk, Shopping Guide, Traffic Information Disy Smart HomeSmart Home Control Bar, Smart Panel, Smart Mirror Disy Bar, Smart Speaker Disy Automotive DisyCar Dashboard, Center Console Bar, Rearview Mirror Disy, HUD Disy Industrial HMIIndustrial Automation Bar Disy, PLC Control Panel, E Status Bar, Production Line Disy Security MonitoringSecurity Monitoring Bar Disy, Access Control Intercom Bar, Video Surveillance Bar, Building Intercom InstrumentationOscilloscope, Spectrum Analyzer, Laboratory Instrument Panel, Power Meter Elevator DisyElevator Floor Indicator Bar, Building Information Disy, Cabin Control Panel️ Development & EvaluationEmbedded Development Board, Raspberry Pi Expansion Screen, FPGA Evaluation Disy, LVDS Signal Demo

⚠️ Note: All parameters above are based on the official Product Specification (LS29I01-L-V1（SPEC）.pdf, Revision: 1.0, Uploaded: 2026-04-23). This model is a 29-inch ultra-wide bar type disy module with 8-bit 2 Channel LVDS interface, featuring 1920x618 ultra-high resolution, 500 cd/m² typical brightness, up to 4000:1 ultra-high contrast ratio, and approximately 89° wide viewing angle. It is widely applicable for digital signage, smart home, automotive dashboard, industrial HMI, security monitoring, instrumentation, and elevator disy scenarios. This module is an OpenCell type without LED driver, re an external 55V/400mA backlight power supply. The typical VDD supply voltage is 12V, with ripple less than 10% and minimum voltage not lower than 10.8V. Actual performance may vary; please refer to samples or final contract for production. Some optical parameters are typical values and may have a ±5% tolerance. This module is RoHS compliant.