铁路道钉锚固砂浆
railroad spike anchoring mortar
1特点features
铁路混凝土轨枕、桥枕的道钉，大多采用硫磺锚固剂锚固。硫磺锚固道钉要熬制硫磺，对环境造成污染，施工也较麻烦；混凝土局部受热可能产生裂缝，降低道钉使用寿命。td型道钉锚固剂是以无机混合料为原料的新型高强锚固材料，它具有快硬、高强、微膨胀、冷操作施工等特点。特别是省去加热工序，对环境无污染，避免了现场施工的火灾隐患。轨枕道钉锚固后，经200万次疲劳试验效果良好。
concrete sleeperrailway bridge pillow of the spike, mostly using sulfur anchoranchoring agent. sulfur anchor spike to be brewed sulfur, resultingin environmental pollution, construction, are more trouble;concrete cracks of local heat may reduce the spike life. td-typespike anchoring agent is a mixture of inorganic raw materials, newhigh-strength anchoring material, it has a fast hardening, highstrength, micro-swelling, cold operation of construction and so on.in particular, eliminating the need for heat treatment,environmental pollution, to avoid construction-site fire hazard.sleeper anchor spike up after two million times of fatigue testsare positive.
2使用范围usage
2.1.铁路混凝土轨枕、桥枕的道钉锚固；
railway concretesleeper, the bridge pillow of the spike anchor
2.2.装配式桥梁的胶结接头的锚固；
prefabricatedbridges anchoring cemented joints
2.3.机械设备地脚螺栓的锚固；
. machinery ande anchor bolts for anchoring
2.4.混凝土结构加固工程中牵钉的锚固。
concrete structurereinforcement project pull nail anchor
3主要技术指标technicalindicators
4使用方法use
1.清除孔内杂物、粉尘及污染物。
clearance hole debris, dust andcontaminants
2.在锚固孔底用木塞、粘土等堵严，防止漏浆。道钉的锚固深度不得小于150mm。
in the end of anchoring holeswith cork, clay, etc. block strict, to prevent slurry leakage.spike anchoring depth of not less than 150mm.
3.清除道钉表面的铁锈、油污。
remove spike surface rust,grease
4.将锚固剂倒入搅拌锅内，称取锚固剂重量13～14%的水，与锚固剂一起拌合2～3分钟。
will be anchoring agent into themixing pot and said anchoring agent to take the weight of 13 ~ 14%of the water, mixing together with the anchoring agent 2 ~ 3minutes.
5.将拌合均匀的锚固剂，灌注入道钉予留孔中，用捣固捧捣实。
the mixing uniform anchoringagent, filling the hole into the spike to the left, using tampingtamping moral support.
6.将道钉从灌注孔上部旋转压入灌满锚固剂的孔正中，套入道钉定位板，用另一根道钉轻轻敲击道钉头部，使锚固剂振动密实。
will spike from the perfusionpressure into the hole filled with rotating upper anchoring holesin the middle of agents, set spike into the positioning plate,gently tapping with another root spike spike head, so thatvibration compacting anchoring agent.
7.当锚固剂硬化抗压强度＞35mpa时，即可受力。
when the anchoring agent hardening compressive strength> 35mpa,they can force.
5 注意事项notes
1.td型道钉锚固剂可在低温或负温条件下使用，但由于气温较低，硬化时间加长。
td-type low-temperature spikeanchoring agent can be used under or negative temperatureconditions, but because of the lower temperatures, curing timelonger.
2.当在绝缘要求较高的线路上使用时，需经有关部门认可。建议使用绝缘套管或在道钉上涂抹绝缘胶。
when the insulated linesre high use should be subject to approval by relevantdepartments. recommend the use of insulating sleeve or insulatingplastic spike on the smear.
3.td型道钉锚固剂应防止受潮，受潮的锚固剂不得使用。其有效期为一年。
td-type spike anchoring agentshould prevent the damp, wet anchoring agent shall not be used. isvalid for one year.
展开全文