汇众蓄电池|HUIZHONG电池Co., Ltd

汇众电瓶|huizhong充电电池co., ltd

铅酸电池密封性免维护保养充电电池商品。2v、4v、6v、8v、12、24v标准彻底，商品优点为：

1.高品质、很高的可靠性

2.应用长寿命

3.无分散锂电池电解液，无腐蚀汽体泄露，对自然环境 ，节能型

4.镀金铜接线端子，导电率能,外观设计好看

5.可深充放电，耐过充过放

6.习惯性溫度经营规模广（-40o ~ 60o）

7.尤其密封性整体规划，决不会泄露锂电池电解液，应用安全性，三维方位可随意应用

8.充电电池充放电至零工作电压坚持不懈一个月，电池充电仍可恢复

9.锂电池寿命小，每月低于3%，置放长寿命,存储2年不无效

汇众电瓶特点：

1、汇众胶体溶液锂电池电解液的应用，使商品在生产、应用和取回全过程中，对自然环境的危害降至了。极片采用尤其研制开发的切合标准的铅钙锡铝合金极片。

2、铅酸电池在小于0℃的自然环境下应用容积急剧下降，huizhong胶体电池在-40℃至70℃自然环境都可以一切正常应用。在-20℃自然环境下，仍可以开释附加容积的80%之上。

3、胶体溶液电解质溶液和尤其铝合金保证了电瓶 的电池充电接纳工作能力。

4、大电流量聚合物电芯充放电，在10c充放电5秒内充电电池。

5、可存储2年不用电池充电就可以应用，2v系列产品静放2个月容积仍储存99.9%之上。

6、经频繁不断深充放电至0v仍能一切正常恢复，可降低1.75v/单格的低限维护保养，这对深循环系统充电电池十分关键。

7、适用-40℃～70℃溫度经营规模内及高原地区自然环境中依然一切正常工作。

8、超纯原材料和胶体溶液保证了电瓶在一切正常自然环境下浮充应用使用寿命达十年之上。

9、免国际惯例密封性铅酸电池由于锂电池寿命因素，在20℃自然环境中寄放大半年，要求开展一次性/电池充电维护保养，要不然伤害充电电池，危害应用。汇众胶体电池由于锂电池寿命很小，又无记忆性，常温下寄放1-2年容积仍能坚持不懈允差容积的85%，此项总体目标居 水准。

产品名字

汇众企业太阳能发电专用型密封性铅酸电池

商品用途

太阳能发电，风能发电，ups，eps开关电源，气动工具等

商品颜色

以灰白为主导，根据库存量也是有灰黑色，墨绿

关键特性

具备密封式，长寿命，深循环系统特性好等特点

包装设计

以包装纸箱为主导，量大可以木箱包装

商品原材料

铅，盐酸，abs塑料

商品优点

密封式整体规划，极高

常见问题

原厂前已经充满电，防止短路故障

充电电池构造

1、锂电池电解液固定不动方式：锂电池电解液由汽体二氧化硅及多种多样防腐剂以胶体溶液方式固定不动.引入时为液体，可充满充电电池内的一切室内空间。

2、极柱密封性方式：双层耐酸性硅胶圈伸缩式密封性，保证了应用使用寿命中后期极群发展时的密封性。

3、极片：铅钙锡无锑多元化铝合金，列管式或是涂膏式极片。尤其加工工艺，晶格常数细微匀称，耐蚀性好，充电电池的应用长寿命。

汇众电瓶产品特性：

1、 免补水保湿、维护保养简易

选用独特设计方案摆脱了充电电池在电池充电全过程中电解法缺水的状况，充电电池在应用全过程中液压容积和比例基本上沒有转变，因而充电电池在使用期期内彻底不用补水保湿，维护保养简易。

2、 密封性安全性、安装操作方便

充电电池内沒有流动性的液压，充电电池立柱式、侧睡安裝应用均可，无液压漏水之患，并且在一切正常电池充电全过程中充电电池不容易造成有机气体。因而可将充电电池安裝在办公室或配套设施机器设备屋内，而不用另建专用型充电电池房，减少工程预算。

3、 使用期长

选用了耐腐蚀性优良的铅钙合金铝板栅，在25℃的工作温度下，一切正常浮充使用寿命达到十年之上。

4、 大功率充放电特性好

选用了内电阻值不大的高品质极片和玻璃纤维挡板，并且安装过紧，促使电池内阻很小。在-40℃~60℃温度范围内开展大电流量充放电，其功率比基本充电电池可高于15%上下。

5、 安裝方便使用

充电电池原厂时早已彻底电池充电，客户取得充电电池后就可以安裝交付使用。

advantages of huizhong battery products:

1. good safety factor: under all normal applications, no lithiumbattery electrolyte exposure, no charging battery swelling andcracking.

2. good charge and discharge characteristics: stable chargingand discharging voltage, light charging and discharging serviceplatform.

3. good vibration resistance: the fully charged battery iscompletely fixed and vibrates for 1 hour at a vibration amplitudeof 4mm and a frequency of 16.7hz. there is no liquid leakage,swelling and cracking of the rechargeable battery, and the opencircuit voltage is normal.

4. good shock resistance: a fully charged battery will fall froma height of 20 cm to a centimeter thick hardwood board three times.no liquid leakage, no charging battery swelling and cracking, opencircuit voltage is normal.

5. good overcharge and discharge resistance: the rechargeablebattery with complete battery charge at 25 ℃ will be charged anddischarged with fixed resistor for three weeks (the resistancevalue is equal to the resistor specified for 1ca charging anddischarging of the rechargeable battery), and the repair volume isabove 75%.

6. good overcharge resistance: the 0.1ca rechargeable batteryunder the condition of complete battery charging at 25 ℃ for twodays has no liquid leakage, no swelling and cracking of therechargeable battery, the open circuit voltage is normal, and thevolume retention rate is above 95%.

7. good resistance to large current: the charge and discharge of2ca or 10ca are about 5 minutes or 5 seconds respectively. noelectrical conductivity, part of the melt, no deformation.

battery characteristics

(1) long service life, high toughness and tight machiningtechnology can improve the tightness of charging batteryinstallation, avoid the falling of active chemicals, and improvethe service life of rechargeable batteries. the low acid ratiohydraulic pressure can improve the charging acceptance capacity ofthe battery and improve the working capacity of the deep chargingand discharging cycle system of the rechargeable battery. thedesign scheme of increasing acid content ensures that the chargingbattery is not easy to reduce the service life of the rechargeablebattery due to the lack of electrolyte. therefore, the service lifeof gfm series battery is over 15 years (25 ℃)

(2) the polymer cell has high , high toughness, compactmachining technology, small internal resistance, high flow chargeand discharge characteristics, which is 280 [%] higher than that ofordinary rechargeable batteries.

(3) lithium battery life is low, high-purity raw materialsue manufacturing process, lithium battery life is not long,indoor temperature storage for more than half a year can also needno power supply.

(4) simple maintenance, unique co2 digestion and absorptioncycle system design scheme, get rid of the charging battery in thewhole process of battery charging electrolytic water shortage, inthe whole process of application of lithium battery electrolytemoisture composition basically did not change, so the chargingbattery in the whole process of application without watermoisturizing, maintenance is simple.

(5) with high safety factor, special valve is e insidethe rechargeable battery, which can reasonably protect the externalfire, and is not easy to cause explosion accident inside therechargeable battery.

(6) simple installation of rechargeable battery, column type,side sleep, stack installation can be used, the installation ofsmall footprint, convenient and convenient.

(7) it is not easy to cause organic gas when using rechargeablebattery for clean environment protection. it is corrosion-resistantto the surrounding environment and supporting facilities. therechargeable battery can be installed in the office or thesupporting facilities and e room without corrosionprotection.