南澳电气专业生产NAGP工频信号发生器

 nagp工频信号发生器

nagp frequency signalgenerator

 本仪器采用单片机波形合成发生器产生高精度，低失真的正弦波电压，可用于校验频率继电器，同步继电器等，也可作为低频变频电源使用。

 本仪器具有读数直观，，性能稳定，操作方便等特点。关键器件采用进口元件，是一种有着较高性能价格比的试验仪器。

二、基本原理

 工频信号发生器，主要由数字波形发生部分、功率放大部分、以及中央控制单元等组成。通过前面板控制数字波形发生单元产生一个频率及幅度非常稳定的数字合成的正弦波，然后送到功率放大器进行放大。经过输出切换及短路保护后输出。中央控制单元则负责测量输出频率及输出幅度，并监视整个系统的工作状态是否正常。

项目

技术指标及参数

备注

频率输出范围

1hz ~ 100hz

正弦波

波形失真度

0.5%

电压输出范围

0 ~ 450v

额定输出功率

50va

电压测量准确度

±1%±2个字

满量程

频率测量准确度

±0.02%±2个字

电源

220v±10%

工作环境

环境温度:0°～40°

相对湿度:≤80%

one. overview

this instrument usessingle-chip waveform synthesis generator produces high-precision,low distortion sine wave voltage, can be used touency relays, synchronous relays, etc., can also be useduency inverter power supply.

this instrument has areading intuitive, accurate, stable performance, easy to operateand so on. key components of the use of imported components, is ahigh performance and low cost of the test equipment.

two. basic principles

nagp frequency signalgenerator, mainly consists ofdigital waveform generation part, power amplifier part, and thecentral control unit and so on. through the front panel controldigital waveform generation unit produces a very stable fre amplitude of the digital synthesis of sine wave, and then sentto the power amplifier for amplification. finally, after the outputswitching and short circuit protection output. the central controlunit is responsible for measuring the output frequency and outputamplitude, and monitor the work of the entire system state isnormal.

three. technical indicators

items

technical indicators andparameters

remarks

frequency output range

1hz ~ 100hz

sine wave

waveform distortion

0.5%

voltage output range

0 ~ 450v

rated output power

50va

accuracy of voltagemeasurement

±1%±2个字

full range

accuracy of fre

±0.02%±2个字

supply power

220v±10%

workingenvironment

ambient temperature: 0 °~ 40 °

relative humidity: ≤80%