IAC8000 SF6回收装置

一、概述introduction

        本装置系用于sf6气体绝缘电气设备的制造、使用及科研部门从sf6设备中回收，净化sf6气体，并有抽真空及充气能力的专用设备。thisis a special purpose device， which can be used to reclaim andpurify sf6 gas from the sf6 gas insulated electric e bypersons who manufacture，user or research into the e。thisdevice also has the functions of vacuum-pumping and gasfilling。

二、功能function

1、该设备能对sf6电器开关抽真空并测定真空度。

vacuum pumping thesf6 switchand testing the limited vacuum 。

2、能对sf6电器开关充入sf6气体。

back –filling the sf6 gas into theswitch。

3、能对sf6电器开关的气体进行回收。

reclamation of the sf6 gas from theswitch。

4、能对回收的sf6气体净化处理。

purification and drying treatmentof the reclaimed sf6 gas。

5、存储sf6气体。

storage of the sf6 gas in pressuretank。

三、主要元件mainpart

1、真空泵vacuum pump　model：ulvacvdn401 40m3/h 极限真空0.06pa

2、压缩机compressor model：emerson ca—030012m3/h

3、净化系统filter-driers model：emerson滤芯、 f—03吸附剂 配有活化加热系统。it is used to filter anddry the gas。there is a f-03 absorption activating and heatingsystem。

4、冷却系统 coolingsystem

热交换器，制冷系统，风冷机组 可使sf6液化存储。heat-exchanger，refrigeratingcompressor，air cooling unit

5、存储罐pressuretank

40kg容器，安全阀，压力3.8mpa

40liter safety valvepressure 3.8mpa

6、阀门valve

球阀ball-valve

7、控制系统controlsystem

可进行装置的各项操作和仪表监视。

using the control system，you can operate thedevice and monitor all the instruments。

8、连接管道rubberhose

四、技术参数 technicalparameters

1、 抽真空速率rate ofvacuum：40m3/h 真度limited vacuum：10pa

2、 充气速率rate ofback-filling：12m3/h

3、 回收速率rate ofreclamation：12m3/h

4、 sf6回收率reclamationpercentage：95%左右(根据配置选择)

5、 工作环境温度：working environmentaltemperature：

upper limit：+45℃ ， lower limit：-10℃

6、 存储罐pressuretank：40kg 3.8mpa

7、 回收初压力first pressure ofreclamation：8bar

8、 机组重量weight of thedevice：380kg

9、 电源power：three-phase380v±10%， 50hz

10、 功率： power：10kw

generalsafety notes

(一般安全注意事项)

obligation to exercise duecare

the device has beendesigned and constructed bearing in mind the standard to beobserved as well as additional technicalspecifications.

设备已经设计好，制造时要按照标准和额外的技术规范。

safe use of the machinecan only be achieved if all the necessary measures arefollowed.

如果遵守必要的措施，就可以做到机器的安全使用。

the operator has toensure that

操作者必须确保以下几点：

- the device is only used for thepurposed for which it is intended (see chapter 2 productdescription

设备只可以用于完成既定的目标。（见第二章产品简介）

- the device is only operated inaccordance with the instructions and in good condition and that thesafety devices are regularly checked.

设备只可以在情况良好的状态下操作，它必须定期维护。

- maintenance and repair personnelare issued with all the required safety and protective clothing ,which shall always be used.

维护人员在解决问题时必须要安全措施和穿必须穿防护服。

- complete and legible operatinginstruction are available on site.

完整清晰的操作说明书是很有用处的。

- only personnel operatesor repairs the device.

只有有资质的人员才可以操作或维修设备。

- this personnel is regularlyinstructed in safety procedures and environment protection and thatthis personnel is fully aware of the complete operating instructionand particularly in the safety notes.

这些人员要接受有规则的安全程序和环境保护，他们也必须充分了解操作说明书和安全守则。

- the safety and warning notesmounted on the device are legible and notremoved.