高压绝缘子ZJ9-10Q-100X125~145 国际认证
- 供应商
- 乐清市皇星开关厂
- 认证
- 品牌
- 皇星
- 连接结构标记
- 见图纸
- 联系电话
- 86 0577 62995008
- 手机号
- 13968757076
- 联系人
- 陈成闯
- 所在地
- 乐清市北白象镇西刘宅村
国家电网电力工业电气设备质量检验测试中心-检测报告
报告编号:(2007)瓷字 第214查询地址:https://china-com.cn/in
乐清市皇星开关厂
huangxing switchesfactory-环氧树脂户内高压绝缘子zj9-10~145
产品使用说明
product operationinstruction
【产品概述】
样本中所列的各种绝缘子和传感器系列均采用环氧真空浇注一次成型,各种套管﹑触
头盒﹑绝缘筒﹑钟形罩等系列产品绝大部分绝缘件采用apg工艺成型,有部分产品采用smc﹑dmc不饱和聚脂增强模塑料压制成型。产品均使用在3.6~40.5kv中压开关柜上。对特殊要求的产品﹑规格尺寸需改进的可按用户要求设计制造。
【product sketch】
the variety of insulation and sensor listed insample all adopt epoxy vacuum pouring technology for one-timemolding,kinds ofbushing﹑contact box﹑insulating cylinder and bell housing etc adoptapda technology for molding(majorty).while,some product adoptsmc﹑dmc unsaturation alkyd enlargement mode plastic for compactingmolding。all the product are applied to 3.6~40.5kv mid-large voltswitchboard ,for some product and specification size owning specialre ,it could be designed and manufactured according touser demand。
【正常使用环境条件】
1﹑海拔高度不超过1000米,高原型海拔高度不超过3000米;
2﹑环境温度在-10℃~+40℃之间,日平均温度不超过30℃;
3﹑相对温度日平均不大于95%,月相对温度平均值不超过90%;
4﹑周围空气没有明显的尘埃﹑烟﹑腐蚀性或可燃性气体﹑蒸气及盐雾的污染;
5﹑安装场所应无经常的振动和严重的颠簸;
6﹑产品均能在凝霜及ⅱ级污秽条件下运行;
【normal operation environmentcondition】
1﹑altitudecan’t exceed 1000m,and the altitude of plateau type can’t exceed3000m;
2﹑surrounding temperature ranges from -10℃ to+40℃,and the daily average temperature;
3﹑dailyaverage value of relative humidity can’t exceed 95%,and the monthlyaverage;
4﹑there isno any dust﹑smoke﹑pollution of corrosive or flammable air﹑vapor andsalt fog;
5﹑there isno any frequent vibration or bumping in installationplace;
6﹑theproduct all could run in the case of dew and ⅱ feculencecondition;
【执行标准】
1﹑gb311.1-1997《高压输变电设备的绝缘配合》
2﹑gb/t7354-2003《局部放电装置》
3﹑dl/538-1993 《高压带电显示装置技术条件》
4﹑dl/t539-1993《户内交流高压开关柜和元部件凝霜及污秽试验技术条件》
5﹑jb/t10305-2001《3.6kv~40.5kv高压设备用户内有机材料支柱绝缘子条件》
6﹑gb/t《高电压试验技术》
7﹑gb/t11022-1999《高压开关设备和控制设备标准的共用技术要求》
【execution norm】
1﹑gb311.1-1997《insulation coordination of highvolt electric transmission and transformatione》
2﹑gb/t7354-2003《partial dischargemeasuring》
3﹑dl/538-1993《high volt charged display device’stechnical condition》
4﹑dl/t539-1993《dew and feculence testingtechnical condition of indoor ac high volt switch board andcomponent》
5﹑jb/t10305-2001《technical condition of3.6kv~40.5kv high volt e indoor organic material postinsulator》
6﹑gb/t《high-low volt testingtechnical》
7﹑gb/t11022-1999《share technical demand ofhigh-volt switching e and controle》
【订货须知】
1﹑订购支柱绝缘子和传感器时,请提供产品型号﹑安装嵌件孔距﹑螺纹孔尺寸和产品高度;
2﹑订购穿墙套管请提供安装孔和母排孔尺寸;
3﹑订购绝缘筒和触头盒,请提供型号﹑额定电流;
4﹑用户如对产品外形尺寸或技术参数变动,订购时请加以特别说明,可根据要求进行设计﹑开发。
【order notice】
1﹑whenordering post insulator and sensor,please give productmodel﹑installation embed-unit pitch﹑threaded hole size and productheight;
2﹑pleasegive size of installation hole and bus-bar block hole when orderingwall busying;
3﹑pleasegive model and rated current when ordering insulating cylinder andcontact box;
4﹑provideduser requires some changing for product outer size or technicaldate,please give special instruction when ordering,we could conductproduct’s design and development according to your specialdemand。
展开全文