BE蓄电池PL12-150精密设备专用应急电源配套12V150AH后备储能电源

供应商
德尔森电源(青岛)有限公司
认证
报价
586.99元每只
品牌
BE蓄电池
型号
PL12-150
容量
12V150AH
手机号
15020021768
联系人
高科
所在地
山东省青岛市城阳区正阳中路216号泰盛城建大厦3122室
更新时间
2023-11-06 06:08

详细介绍

be蓄电池pl12-150精密设备专用应急电源配套12v150ah后备储能电源


澳大利亚pl系列产品结构powerlyte系列电池设计将电池所需的电解液保存在极板和隔板中.电池内无游离电解液。同时特殊设气的能力,气体再化合率高,保证了电池的空封性电池阴阳极板采用特珠高铅钙制成的板(格子体)克填活性物质而制成的极板优棉制成可有数防止正负极板间短路并且可以很好的吸收和保持并压素极板表面防止活性物质脱落。用优良的耐酸性、耐老向开。电池内压过高时放出气体使内压恢复正常,可防止吸入电池外部的空气。电池先。道均采用合成树脂abs制成有足够的强度。在电池盖上的铅套和端子焊接后再用封口树脂双重密封正极红色负极黑色。为提高高倍率放电性能及可靠性加大端子积易于安装

australian pl series productstructure powerlyte series battery design saves theuired by the battery in the electrode plate and separator. thereis no free electrolyte in the battery. at the same time, it has theability of special gas setting and high gas recombination rate,which ensures the air tightness of the battery. the anode andcathode plates of the battery are made of the plate (lattice) madeof tezhu high lead calcium alloy filled with active substances,which is made of excellent cotton, which can prevent the shortcircuit between the anode and cathode plates, and can well absorband maintain and press the surface of the

electrode plate to prevent thefalling off of active substances. with excellent acid resistanceand aging resistance. when the internal pressure of the battery istoo high, release gas to restore the internal pressure to normal,which can prevent inhalation of air outside the battery. batteryfirst. all channels are made of synthetic resin abs with sufficientstrength. after the lead sleeve on the battery cover is welded withthe terminal, seal the positive red and negative black with sealingresin. in order to improve the high rate discharge performance andreliability, increase the terminal area and make it easy toinstall

性能特点

1、安全性能好:正常使用下无电解液漏出,无电池膨胀及破裂。

2、放电性能好:放电电压平稳,放电平台平缓。

3、耐震动性好:完全充电状态的电池完全固定,以4mm的振幅,16.7hz的频率震动1小时,无漏液,无电池膨胀及破裂,开路电压正常。

4、耐冲击性好:完全充电状态的电池从20cm高处自然落至1cm厚的硬木板上3次。无漏液,无电池膨胀及破裂,开路电压正常。

5、耐过放电性好:25摄氏度,完全充电状态的电池进行定电阻放电3星期(电阻值相当于该电池1ca放电要求的电阻),恢复容量在75%以上。

6、耐过充电性好:25摄氏度,完全充电状态的电池0.1ca充电48小时,无漏液,无电池膨胀及破裂,开路电压正常,容量维持率在95%以上。

7、耐大电流性好:完全充电状态的电池2ca放电5分钟或10ca放电5秒钟。无导电部分熔断,无外观变形。

事实证明,平均使用环境温度每升高10摄氏度,电池的寿命就减半。

自1987年batteryenergy公司成立以来,我们一直致力于推动各种电池技术的发展,包括提高电池的电性能、延缓活性物质延长电池的循环和浮充使用寿命。目前,batteryenergy的超级胶体电池技术在循环和浮充使用两方面都于世界,且被众多专家所认同。

采用超级胶体电池技术生产的电池能适用于各种恶劣的环境,应用于铁路机车的railgel系列电池还具有独特的耐振动结构设计。


澳大利亚BE蓄电池PL12-150铅酸免维护阀控式12V150AH详细参数说明

展开全文

我们其他产品
我们的新闻
优质商家推荐 拨打电话