PPS Z650低吸水PPS

pps z650低吸水pps---pps is resistance heat especially; molding ofproperties

 mold, therefore. crystallinity of degree by affected

 injection in important particularly is temperaturewall

 above be should it, basically. pps.dic of molding

 .tc1,temperature crystallization-post the is thatc˚120

 is c˚150 to 130 of temperature wall mold the

 temperature deflection the. recommended generally

 resistance heat of indicator the is) dtul (load under

 is dtul of dependence temperature mold the and

.16.6.fig in show

 impact and flexural on temperature mold of effect the

 .respectively 18.6 and 17.6. strengths

 mold as reduced slightly is strength flexural

 polymer linked cross on increased is temperature

 ,hand other the on. 3600─fz and 1140─fz based

 temperature mold as increases strength flexural

 impact the. based polymer linear the for increasing

 mold as compounds all for reduced is strength

.increased is tem

聚苯硫醚：特别是耐热性；性能的塑造

因此，模具。结晶度受温度的影响

注射中特别重要的是壁温

基本上应该是上面的。pps.dic公司成型工艺

.tc1，结晶后温度为c˚120

是模具壁温的150到130摄氏度

温度偏差。一般推荐

指示器的电阻热为dtul（负载下

取决于温度和模具

图16.6.图示

影响和弯曲对模具温度的影响

分别为18.6和17.6。强度

模具强度略有降低

聚合物的交联温度升高

，另一只手。基于3600–fz和1140–fz

随着温度的升高，模具的抗弯强度增加

影响。线性聚合物

模具为复合材料，强度降低

.增加了tem